Filter
Top Products
Setting Up 3DM Preferences
www.3ware.com 27
To enable or disable remote access
1 Click
3DM 2 Settings on the menu bar.
2In the
Remote Access section of the 3DM 2 Settings page, select either
Enabled or Disabled in the Allow Remote Connections field.
The page refreshes, and a message at the top of the screen confirms that
remote access has been enabled or disabled.
Setting the Incoming Port #
You can set the port which 3DM uses to listen for incoming messages. If you
are not sure which port would be the best to use, leave this set to the default
port of 888.
To set the incoming port
1 Click
3DM 2 Settings on the menu bar.
2In the
Incoming Port # section of the 3DM 2 Settings page, enter the port
number in the
Listening Port field.
3 Click
Change Port.
The page refreshes, and a message at the top of the screen confirms that
the listening port has been changed.
Setting the Frequency of Page Refreshes
Since the status of the drives attached to your 3ware RAID controller can
change while you are viewing information about them in 3DM, it is important
to refresh the page information regularly. That way you can be assured that
the information you see in 3DM is current.
You can manually refresh the information on a page by clicking
Refresh
Page
in the menu bar. But you can also have 3DM refresh the information on
a regular basis.
To set the frequency of page refreshes
1 Click
3DM 2 Settings on the menu bar.
2In the
Page Refresh section of the 3DM 2 Settings page, select how often
you want the page to be refreshed in the
Minutes Between Refresh field.
Note: If you do not want 3DM to refresh the screen automatically,
select
Never in the Minutes Between Refresh field. You can
then refresh manually by clicking Refresh on your web browser.