Filter
Top Products
CM1164 User Manual
8
IR Remote Control
No. Component Description
1 OSD button Press this to turn on/turn off the OSD menu.
When the OSD menu is enabled, press the OSD
button to go back to the previous menu/submenu.
2 Fn1 / Fn2 / Fn3 / Fn4
Buttons and Select
Button
Use these buttons to switch between Function modes
(Fn1 to Fn4), and to cycle through the OSD menu/
selection.
See FN Keys, page 23 for details on how to store
function mode settings, which you can invoke for later
use.
The Fn1~Fn4 buttons are positioned to correspond to
the up / down / left / right direction.
When cycling through the menu options, press the
Select button to go the submenu.
If you want to change or adjust a selection/value,
press the Select button then the Fn1 (up) / Fn2 (left)
/ Fn3 (down) / Fn4 (right) buttons to go through all
the selections/values. Press the Select button again
to confirm a selection.
3 Display Mode buttons Select the Display Mode you want to view. See Display
Modes, page 18.
4 Port Selection Buttons
1~4
Press these buttons to switch ports (1~4).
5 Station Selection
Buttons
If the CM1164 is daisy chained to one or several units
(up to 4), press the button corresponding to the
CM1164 device that you want to configure or operate.
2
5
3
4
1
cm1164.book Page 8 Thursday, August 16, 2012 4:50 PM