Filter
Top Products
PN9108 User Manual
40
4. The wording for the System after AC Back function may vary somewhat
from system to system. For example:
AC Loss Auto Restart
Restore on AC Power Loss
In the BIOS settings, choose Power On (Full On).
5. NT systems must use the System after AC back function.
Automated Setup
There are two methods to set up safe shutdown and rebooting: Automated, and
Manual. This section discusses an automated setup. Manual setup, is discussed
on page 42. Automated setup is made possible with the use of the Power
Monitor utility supplied on the software CD that came with this package.
Note: Power Monitor only works with Windows systems.
Power Monitor watches the computer's power status via the UPS signal. If the
UPS signals a power failure and a low battery condition, a dialog box pops up
to inform you that the utility will perform a safe shutdown in a few seconds.
Installation
To install the Power Monitor, simply execute the self extracting setup program
(PMonitorSetup.exe). A copy of PMonitor.exe is placed in the Windows
Startup folder so that it executes each time the system is booted.
When monitoring is in effect, a monitoring icon in the form of lightning bolt
( ) is placed in the Windows taskbar to indicate so. When monitoring is
temporarily disabled, a canceled lightning bolt icon ( ) is displayed.
You can switch between enabled and disabled by right clicking the icon
and selecting Start Monitor or Stop Monitor from the pop up context
menu.
You can exit the program by right clicking on the icon and selecting Exit
from the pop up context menu.