Filter
Top Products
PN9108 User Manual
64
Dial Out Connection
This configuration sets up a connection for the PN9108 to an ISP's site. You
can use the dynamic IP address that the ISP assigns to the PN9108 to access it
with a browser.
Connection Setup
1. Set up your hardware configuration to match the diagram, below:
Note: Use a standard 9 pin serial modem cable to connect the modem to
the PN9108's RS-232 port.
2. In the Out of Band Configuration dialog box (see page 47):
a) Make sure that the Enable dial-out function setting is enabled (there is a
check mark in the box).
b) Fill in the Com Port, ISP, and Modem settings with values appropriate
for connecting to your ISP.
Note: 1. If your modem isn't in the drop down list, select Generic
Modem as the modem type.
2. If you choose Generic Modem, you must specify any
necessary initialization commands in the Initialization String
textbox. The commands should be separated by a semicolon
( ; ). If you leave the initialization string blank, the PN9108
will only issue the atdt command.
Modem
Phone Line
PN9108
Serial Cable
ISP