Axis Communications A1001 Network Router User Manual


  Open as PDF
of 63
 
AXIS A1001 Network Door Controller & AXIS Entry Manager
System Configuration
System Configuration
To open the product’s Setup pages, click Setup in the top right-hand corner of the Overview page.
The Axis product can be congured by administrators. For more information about users and administrators, see page 24, page 29,
and page 41.
Conguration – Step by Step
Before you start using the access control system, you should complete the following setup steps:
1. If English is not your rst language, you may want AXIS Entry Manager to use a different language. See Select a Language
on page 12.
2. Congure the door controller and connected devices such as readers, locks and request to exit (REX) devices. See Congure
the Hardware on page 13.
3. Verify the Hardware Connections. See page 17.
4. Set the date and time. See page 17.
5. Congure the network settings. See page 18.
6. Congure card formats. See page 19.
7. Congure the door controller system. See Manage Network Door Controllers on page 21.
For information about how to congure and manage the system's doors, schedules, users and groups, see Access Management on
page 24.
For information about maintenance recommendations, see Maintenance Instructions on page 23.
Note
To add or remove door controllers, to add, remove, or edit users, or to congure the hardware, more than half of the door
controllers in the system must be online. To check the door controller status, go to Setup > Manage Network Door
Controllers in System.
Select a Language
The default language of AXIS Entry Manager is English, but you can switch to any of the languages that are included in the product’s
rmware. For information about the latest available rmware, see www.axis.com
You can switch languages in any of the product’s webpages.
To switch languages, click the language drop-down list
and select a language. All the product’s webpages and help pages are
displayed in the selected language.
Important
• Language selection is supported from rmware 1.25. If the door controller uses an earlier version, you need to upgrade the
rmware before you can select a language. See Upgrade the Firmware on page 51.
• Language settings are not shared between door controllers in the system. Either select the language in all door controllers,
or always open Axis Entry Manager from the same door controller.
12
 previous next