Filter
Top Products
3-33-3
3-33-3
3-3
HOW TO USE ON-SCREEN PROGRAMMING (OSP) AND HELP KEY
3550-US-5.0
Ch. 3Ch. 3
Ch. 3Ch. 3
Ch. 3
There are three types of contrast settings.
Usually the AUTO setting is acceptable. But
if you want to send or copy an especially light
or dark document, you should change this
setting.
AUTO: Default setting is AUTO. Contrast
setting always reverts to AUTO after
one transmission.
S. LIGHT: To send very light documents.
S. DARK: To send very dark documents.
If you need to send a set of originals at
various resolutions, this function will allow
you to set the required resolution page by
page. (If all documents are the same
resolution, use the Resolution key. See page
2-5 #21.)
STANDARD/FINE/S. FINE/PHOTO
If you have trouble when sending overseas,
you may want to set OVERSEAS MODE to
ON.
ON/OFF
An automatic Cover Page will allow you to
send details of who the fax is going to, who it
is from and when it was sent. ON/OFF
If you wish to cancel a job that has been set
with the timer, a polled job etc., use this
function.
You can print several different lists and
reports, which are available under function
item 3. PRINT REPORTS.
If you register names and numbers on One-
Touch dial keys, you can dial a number
automatically just by pressing a One-Touch
key. (Max. of 40 locations)
If you register names and numbers as Speed-
Dial numbers, you can dial a number
automatically just by pressing the Speed-
Dial key and a two-digit number. (Max. of
100 locations)
This is used for setting up a group number
used for broadcasting.
Page
Level one
function
Factory
setting
Level two
function
Explanation of Options
3. SETUP
GROUPS
1. ONE-TOUCH
DIAL
4. SET AUTO
DIAL
4-8~9
2. SPEED-DIAL 4-6~7
4-4~5
3. PRINT
REPORTS
See page 11-1 for
a list of reports.
11-1~5
2. CANCEL
JOB
6-11
7. COVERPAGE OFF
6-17~18
6. OVERSEAS
MODE
O FF 6-12
5. RESOLUTION
STAN-
DARD
6-13
AUTO 6-34. CONTRAST
1. TEMP.
(TEMPORARY)
SETTINGS