Filter
Top Products
Confidential
3-41
(3) Remove the two pan (washer) B M4x14 Taptite screws, and then pull out the Fuser unit to
the back of the machine.
Fig. 3-17
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten
it according to the specified torque with a screwdriver.
Assembling Note:
When assembling the fuser unit, make sure that the two Harnesses are placed in the
groove and under the rib of the Plastic frame. If they are not, then correct them as shown
in the figure below.
Fig. 3-18
Fuser unit
<Back side>
Plastic frame
Harness
Harness
Taptite, pan (washer) B M4x14
(Tightening torque: 1.20 ±0.1 N m) *1
Taptite, pan (washer) B M4x14
(Tightening torque: 1.20 ±0.1 N m) *1