Filter
Top Products
Confidential
1-4
Error
codes
Problem
Refer
to:
Error
codes
Problem
Refer
to:
85 Tray 1 (T1) is not installed into the
machine.
1-23 B5 Detection error of horizontal scanning
edge reduction in scanning area setting
1-29
86 Tray 2 (T2) is not installed into the
machine.
1-23 B6 Detection error of horizontal scanning edge
magnification in scanning area setting
1-29
88 Paper jam inside the machine 1-22
8A Paper jam in Tray 1 (T1) 1-24
B9 Scanning light adjustment error is
detected.
1-29
8B Paper jam in Tray 2 (LT) 1-24 BB White level data error 1-29
8C Paper jam in MP tray (MP) 1-24 BD Black level data error 1-30
BE Detection error of scanning starting edge 1-3099 Specified paper size is not supported
for duplex printing (DX).
1-7
BF Duplex scanning cannot be
implemented due to too long document.
1-30
9B Request on developing bias voltage
adjustment
1-7
C0 Identification failure for a new toner
cartridge (K)
1-31
9D Incorrect sensor measurement value
when implementing auto color
registration from the control panel
1-25
C1 Identification failure for a new toner
cartridge (Y)
1-31
A2 Document is too long. 1-25 C2 Identification failure for a new toner
cartridge (M)
1-31
A3 Document rear sensor is not turned
on when feeding the document.
1-25
C3 Identification failure for a new toner
cartridge (C)
1-31
A5 Fax scanning error
(The first warning only)
1-26
C4 Tray 2 (LT) plate-up function malfunction 1-32
C5 EL lamp electrifying failure 1-32
C6 Toner cartridge mis-dividing 1-32
A6 Fax scanning error
(The second warning that the same
error with A5 occurs again)
1-26
C7 Insufficient DIMM memory 1-7
A7 Color parameter failure 1-26 C8 RAM area for secure data full 1-33
AD DMA transfer error 1-26 C9 Defective DIMM is installed. 1-7
CA Excess current to USB device 1-33AE FB unit home position sensor is not
turned on.
1-27
CB Belt unit is not installed into the machine.
1-33
AF FB unit home position sensor is not
turned off.
1-27 CC Fuser unit is not installed into the
machine.
1-34
B0 Harness for CCD unit is not
connected correctly.
1-28 CD Drum unit is not installed into the
machine
1-34
B2 Gain control data level error for CCD
unit scanning.
1-28 CE Waste toner box is not installed into
the machine.
1-36
CF Waste toner box full 1-36B3 Detection error of the scanning area
on the left end
1-28
D0 –DF Modem error 1-37
E6 NVRAM error on main PCB 1-37
EF Incorrect print coverage value 1-37
B4 Detection error of the scanning area
on the right end
1-28
F8 Battery connection failure 1-37