Filter
Top Products
Confidential
3-167
(2) Remove the three bind B M3x12 Taptite screws and cup B M3x12 Taptite screw, and then
remove the Develop press drive L ASSY.
Fig. 3-246
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it
according to the specified torque with a screwdriver.
(3) Remove the bind S M3x6 Taptite screw, and then remove the Develop release motor ASSY
from the Develop press drive L ASSY.
Fig. 3-247
Frame unit
Taptite, bind B M3X12
(Tightening torque: 0.80 ±0.1 N m) *1
Develop press drive L ASSY
Taptite, bind B M3X12
(Tightening torque: 0.80 ±0.1 N m) *1
Taptite, bind B M3X12
(Tightening torque: 0.80 ±0.1 N m) *1
Taptite, cup B M3x12
(Tightening torque: 0.80 ±0.1 N m) *1
<Left side>
Develop press drive L ASSY
Taptite, bind S M3x6
Develop release motor ASSY