Filter
Top Products
4 - 1
INITIAL SETUP
4
4
Initial Setup
Getting Started
After you have assembled your machine uing the Brother StartCard, continue
the setup by programming the rest of the initial settings.
Setting Date and Time
Your MFC displays the date and time, and prints it on every fax you send.
In the event of a power failure, you may have to reset the date and time. All other
settings remain unaffected.
1
Press Function, 1, 1, 1.
2
Enter the last two digits of the year, and then
press Set.
3
Enter two digits for the month and press Set
(for example, enter 09 for September).
4
Enter two digits for the day (for example, 06),
and then press Set.
5
Enter the time in 24-hour format, and then press Set (for example, enter 15:25
for 3:25 PM).
6
Press Stop.
The LCD now will show the date and time you set whenever the MFC is in
Standby mode.
Setting Station ID
You can store your name, fax number, and telephone number to be printed on
all fax pages you send. (See
Composing Electronic Cover Page, page 6-4 and
Entering Text, page 4-2.)
1
Press Function, 1, 1, 2.
2
Enter your fax number (up to 20 digits),
and then press Set.
(You must enter a fax number to proceed.)
3
Enter your telephone number (up to 20 digits),
and then press Set.
(This number appears on Cover pages.)
If your telephone number and fax number are the same, enter the same number
again. The LCD shows your entry.
ENTER YEAR:XX
ENTER MONTH:XX
ENTER DAY:XX
ENTER TIME:XX:XX
FAX:
TEL:
NAME: