Filter
Top Products
Viewing Chassis Information 2-3
CSX200 and 400 Chassis View
Front Panel Information
The areas surrounding the main chassis area provide the following device
information:
IP
The Internet Protocol address assigned to the CSX appears in the title bar of the
Chassis View window. IP addresses are assigned via Local Management.
Connection Status
This color-coded area indicates the current state of communication between
SPECTRUM Element Manager and the CSX200/400.
¥ Green indicates the CSX200/400 is responding to device polls (valid
connection).
¥ Magenta indicates that the CSX200/400 is in a temporary stand-by mode
while it responds to a physical change in the switch; note that board and port
menus are inactive during this stand-by state.
¥ Blue indicates an unknown contact status Ñ polling has not yet been
established with the CSX200/400.
¥ Red indicates the CSX200/400 is not responding to device polls (device is off
line, or device polling has failed across the network for some other reason).
UpTime
The amount of time, in a X day(s) hh:mm:ss format, that the CSX200/400 has been
running since the last start-up.
Port Status
If management for your device supports a variable port display (detailed in The
CSX200/400 Port Status Displays later in this chapter), this Þeld will show the
display currently in effect. If only a single port display is available Ñ or if the
default view is in effect Ñ this Þeld will state Default.
MAC
Displays the physical layer address assigned to the interface associated with the
IP Address used to deÞne the device icon when it was added to SPECTRUM
Element Manager. MAC addresses are hard-coded in the device, and are not
conÞgurable.
Boot Prom
The revision of BOOT PROM installed in the CSX200/400.
Firmware
The revision of device Þrmware stored in the CSX200/400Õs FLASH PROMs.