Filter
Top Products
Users ln Canada
PRE-INSTALI-ATION REQUIREMENTS
FOR CANON FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See brochure
for unit's
dimensions and weight.
B. Order lnformation
1. Provide
only a single line or touch-tone or
rotary telephone set
terminated with
a standard
4-pin modular
phone
plug.
[fouch-tone
is
recommended
if available in
your
area.)
2.
Order an RJ11-C modular wall
jack
(USOC
code),
which should
be
installed by the
phone
company. lf the RF1 1-C
wall
jack
is not
present,
telephone/fax operation is not
possible.
3.
Order a normal
business
line from
your
telephone
company's business
representative.
The line should be a
regular voice
grade
line or the
equivalent, Use one line
per
unit.
DDD
(Direct
Distance Dial) line
-or-
IDDD
(lnternational
Direct
Dislance dial)
line if
you
communicate
cverseas
Note: Canon recommends an individual
line followinE
induslry standards
such
as the 2500
(touch
tone) or 500
(rotary/pulse
dial) telephones.
A
dedicated extension off a PBX without Camp
On signals
is
also
permitted
with a
FAX
unit. Key telephone systems
are not
recommended because
they send non- standard signals to
individual lelephones
for ringing,
or
send
special codes which may cause a FAX error.
C.
Power Requirements
The
power
outlet should be a three-prong
grounded
receptacle
(single
or
duplex). lt should be independent
from copiers,
heaters, air conditioners
or any electrical equipment that
is thermostatically
controlled.
The rated
value
is 1 15 volts and 15 amperes. The
RJ 1 1-C modular
jack
should
be
reiatively
close to the
power
outlet to
facilitate installation.
NOTICE
The Canadian Deoartment of
Communications
label identifies
certified
equipment.
This cedification means that
the equipment
meets certain
telecommunications
networks
protective,
operational and
safety
requirements.
The
Depanment does
not
guarantee
the equipment
will
operate
to the user's satisfactron.
Before
installing
this
equipment, users
should ensure
that it is
permitted
to
be
connected to the facilities
of the local telecommunications
company
The equipment must also be
installed using an
acceptable method
of
connection.
In some cases, the company's
inside
wiring associated
with
a
single-line
individual service
may be exlended
by
means of a cenified
connector
assembly
(telephone
extension
cord), The customer
should
be
aware
thal compliance with the above
conditions
may not
prevent
deterioration
of service in some
situatrons.