Filter
Top Products
Basic Copying
1
1-23
Selecting an Output Device (Select Output Device)
NOTE
• You must choose a remote copy printer that supports the selected copy settings. The printers that do not support
the chosen settings are shown, but are greyed out. And, even if the remote copy printer supports the Copy mode,
if you select settings other than Collate and Group, you can select only a remote copy printer equipped with the
same finisher as the original copy machine.
• It is impossible to choose two different machines other than your own for cascade copying.
You must include your own machine as one of the output devices.
• If Error Recovery for Cascade Copy is set to ‘On’, the remaining copy job is not processed in the following cases:
- The machine is scanning originals for the Cascade Copy mode.
- The Cascade Copy mode is used in combination with the Cover/Sheet Insertion mode.
- The Cascade Copy mode is used in combination with the Different Size Originals, Auto Paper Selection,
and Two-Sided modes.
- The normally operating printer has completed the cascade copy job.
- An error occurs in the normally operating printer.
- The cascade copy job has almost finished.
- The number of copies is less than six.
• If Error Recovery for Cascade Copy is set to ‘On’, a machine in which an error occurs cannot resume the remaining
copy job even when the machine is recovered after the copy job is reassigned.
3 Press .
Copying starts.
NOTE
• For instructions on how to cancel a remote copy or cascade copy job, see Chapter 2,
“Checking Various Job Operations and Device Status,” in the Reference Guide.