Filter
Top Products
1-26
Selecting an Output Device (Select Output Device)
Basic Copying
1
NOTE
• It is impossible to choose two different machines other than your own for cascade copying.
You must include your own machine as one of the output devices.
• If Error Recovery for Cascade Copy is set to ‘On’, the remaining copy job is not processed in the following cases:
- The machine is scanning originals for the Cascade Copy mode.
- The Cascade Copy mode is used in combination with the Cover/Sheet Insertion mode.
- The Cascade Copy mode is used in combination with the Different Size Originals, Auto Paper Selection,
and Two-Sided modes.
- The normally operating printer has completed the cascade copy job.
- An error occurs in the normally operating printer.
- The cascade copy job has almost finished.
- The number of copies is less than six.
• If Error Recovery for Cascade Copy is set to ‘On’, a machine in which an error occurs cannot resume the
remaining copy job even when the machine is recovered after the copy job is reassigned.
3 From the Basic Features screen, select the copy settings.
NOTE
• When you use a remote copy printer, only those copy settings supported by the selected remote copy printer are
available.
• When cascade copying, you cannot select copy settings that are not supported by the selected remote copy
printer. Also, if you select a remote copy printer equipped with a different finisher, you cannot select settings other
than Collate and Group, even if the remote copy printer supports the specified Copy mode.
4 Press .
Copying starts.
NOTE
• For instructions on how to cancel a remote copy or cascade copy job, see Chapter 2,
“Checking Various Job Operations and Device Status,” in the Reference Guide.