Filter
Top Products
show platform
CF-794
Cisco IOS Configuration Fundamentals Command Reference
July 2008
Command History
Usage Guidelines This command is similar to the show msfc command.
Examples This example shows how to display buffer-allocation information:
Router# show platform buffers
Reg. set Min Max
TX 640
ABQ 640 16384
0 0 40
1 6715 8192
2 0 0
3 0 0
4 0 0
5 0 0
6 0 0
7 0 0
Threshold = 8192
Vlan Sel Min Max Cnt Rsvd
1019 1 6715 8192 0 0
Router#
Cisco 7600 Series Routers with Cisco 7600 SIP-400
This example shows how to display the list of interfaces on which a rate limiter is active for Address
Resolution Protocol (ARP), along with the count of confirmed and exceeded packets for the rate limiter.
Router# show platform copp rate-limit arp
Rate limiter Information for Protocol arp:
Rate Limiter Status: Enabled
Rate : 20 pps
Max Observation Period : 60 seconds
Per Interface Rate Limiter Information
Interface Conformed Pkts Exceeded Pkts Enabled Obs Period (Mts)
GigabitEthernet5/1 0 0 No -
GigabitEhternet5/1.1 14 0 No -
GigabitEthernet5/1.2 28 2 No -
GigabitEthernet5/2 0 0 No -
GigabitEthernet5/2.1 180 4 Yes 35
GigabitEthernet5/2.2 200 16 Yes Max
Router#
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to
Release 12.2(17d)SXB. This command was changed to include the
hardware pfc mode keywords.
12.2(18)SXD This command was changed to include the software ipv6-multicast
connected keywords.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRC This command was modified to include additional keywords to support
CoPP enhancements on the Cisco SIP-400 on the Cisco 7600 series router.