Filter
Top Products
show protocols
CF-858
Cisco IOS Configuration Fundamentals Command Reference
July 2008
show protocols
To display the configured protocols, use the show protocols command in EXEC mode.
This command shows the global and interface-specific status of any configured Level 3 protocol; for
example, IP, DECnet, IPX, AppleTalk, and so on.
show protocols
Syntax Description This command has no arguments or keywords.
Command Modes EXEC
Command History
Examples The following is sample output from the show protocols command:
Router# show protocols
Global values:
Internet Protocol routing is enabled
DECNET routing is enabled
XNS routing is enabled
Appletalk routing is enabled
X.25 routing is enabled
Ethernet 0 is up, line protocol is up
Internet address is 192.168.1.1, subnet mask is 255.255.255.0
Decnet cost is 5
XNS address is 2001.AA00.0400.06CC
AppleTalk address is 4.129, zone Twilight
Serial 0 is up, line protocol is up
Internet address is 192.168.7.49, subnet mask is 255.255.255.240
Ethernet 1 is up, line protocol is up
Internet address is 192.168.2.1, subnet mask is 255.255.255.0
Decnet cost is 5
XNS address is 2002.AA00.0400.06CC
AppleTalk address is 254.132, zone Twilight
Serial 1 is down, line protocol is down
Internet address is 192.168.7.177, subnet mask is 255.255.255.240
AppleTalk address is 999.1, zone Magnolia Estates
For more information on the parameters or protocols shown in this sample output, see the Cisco IOS
Network Protocols Configuration Guide, Part 1, Network Protocols Configuration Guide, Part 2, and
Network Protocols Configuration Guide, Part 3.
Release Modification
10.0 This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.