3-3
Cisco CRS-1 Carrier Routing System 16-Slot Multishelf System Site Planning Guide
OL-7422-04
Chapter 3 Multishelf System Planning
Multishelf System Components
–
12 Gigabit Ethernet cables (4 cables for each LCC and FCC). These (LC to SC) cables connect
to the Cat6509 switches.
or
–
9 Gigabit Ethernet cables (8 RP to SCGE cables (LC to LC) and 1 mesh cable)
• A two-FCC system requires:
–
2 LCCs
–
2 FCCs
–
8 S2 switch fabric cards, which are distributed between the 2 FCCs
–
16 S13 fabric cards (8 cards for each LCC)
–
8 single-width OIMs, which are distributed between the 2 FCCs
–
48 fabric cables for connecting switch fabric cards (24 cables for each LCC)
–
16 Gigabit Ethernet cables (4 cables for each LCC and FCC. These cables connect to the
Cat6509 switches.)
or
–
14 Gigabit Ethernet cables (8 RP to SCGE cables (LC to LC) and 6 mesh cables)
• A four-FCC system requires:
–
2 LCCs
–
4 FCCs
–
8 S2 switch fabric cards, which are distributed across the 4 FCCs
–
16 S13 fabric cards (8 cards for each LCC)
–
8 single-width OIMs, which are distributed across the 4 FCCs
–
48 fabric cables for connecting switch fabric cards (24 cables for each LCC)
–
24 Gigabit Ethernet cables (4 cables for each LCC and FCC. These cables connect to the
Cat6509 switches.)
or
–
36 Gigabit Ethernet cables (8 RP to SCGE cables (LC to LC) and 28 mesh cables)
Control Network (Cisco Catalyst 6509 Switch)
A Cisco Catalyst 6509 Switch (WS-C6509-NEB-A) provides the control network for the multishelf
system control traffic. The Cat6509 switch is connected to the LCCs and FCCs. The following list
describes the requirements for the Cat6509:
• Although the multishelf system can operate with a single Cat6509 switch, we strongly recommend
that you use two switches for redundancy.
Note If you operate the multishelf system with only a single Cat6509 switch, any failure of the
Cat6509 leaves the multishelf system without a control network.
• Each Cat6509 switch requires an SUP720 supervisor controller module and must be running the
following operating system software:
• Cisco IOS Software Release 12.2(14r)S9 or later