Filter
Top Products
2-11
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
OL-1984-06
Chapter 2 Preparing for Installation
Verifying the Shipping Container Contents
In addition, you might need the following cables:
• Straight through cable
• Rollover cable
• Crossover cable
Verifying the Shipping Container Contents
When you receive your Cisco uBR 3x10 RF Switch, use the following procedure to check the contents
of the shipping container. Use the installation checklist and the component list to ensure that you
received all the components you ordered.
Note Do not discard the shipping container. You will need the container if you move or ship your
Cisco uBR 3x10 RF Switch in the future.
Step 1 Verify that the following are included in the shipping container (the accessories box might be separate):
• One Cisco uBR 3x10 RF Switch chassis containing all the components you ordered for your system
• One or more accessories boxes (some or all might be shipped separately)
Step 2 Check the contents of the accessories box against the installation checklist and the packing slip to verify
that you received all listed equipment, which should include everything listed in Table 2-2 and any
ordered Cisco IOS software or other documentation.
Step 3 After provisioning the headend as documented in the next section, refer to the “Rack-Mounting the RF
Switch with the Cisco uBR10012 CMTS” section on page 3-3 to begin the installation.