Filter
Top Products
4
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
OL-1984-06
Preface
Scope
Tip Statement numbers (Statement 1030) at the end of a warning refer to specific warnings and their
translations found in the Regulatory Compliance and Safety Information for the Cisco RF Switch.
Scope
The guide provides installation and cabling information for the Cisco uBR 3x10 RF Switch. Refer to the
“Related Documentation” section on page 10 for related Cisco publications that provide configuration
information for the Cisco uBR 3x10 RF Switch.
Document Organization
This hardware installation guide is organized into the following chapters and appendixes:
Document Conventions
This guide uses the following conventions:
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in
this manual.
Caution Means reader be careful. You are capable of doing something that might result in equipment damage or
loss of data.
Chapter Title Description
Chapter 1, “Cisco uBR-3x10 RF
Switch Overview”
Describes the Cisco uBR 3x10 RF Switch chassis and
components, illustrating the supported system configurations.
Chapter 2, “Preparing for
Installation”
Describes safety considerations, tools, and other equipment
required to prepare your site.
Chapter 3, “Installing the
Cisco RF Switch”
Provides instructions to install and connect cables to the chassis.
Chapter 4, “Cabling the RF Switch
With the Cisco uBR10012 CMTS
Cable Interface Line Cards”
Provides instructions for connecting Cisco uBR 3x10 RF Switch
cable network redundancy cables in a Cisco uBR10012 CMTS
environment.
Chapter 6, “Troubleshooting” Provides basic Cisco uBR 3x10 RF Switch troubleshooting
information.
Appendix A, “Specifications and
Component Part Numbers”
Provides Cisco uBR 3x10 RF Switch system specifications.