Filter
Top Products
CHAPTER
4-1
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
OL-5916-01
4
System Startup
This chapter describes how to start the system and initially configure your Cisco uBR7100 series router.
The chapter contains the following sections:
• Checking Conditions Prior to System Startup, page 4-1
• Starting the System, page 4-2
This chapter guides you through system startup. Complex configuration procedures are beyond the scope
of this publication and can be found in the following publications:
• Cisco uBR7100 Series Universal Broadband Router Software Configuration Guide, at the following
URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr7100/scg7100/index.htm
This document contains sample configurations and procedures for configuring a Cisco uBR7100
series router.
• Modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your
Cisco hardware.
Note For information on other publications, see the “Related Documentation” section on page viii.
To configure a router from a console, you must connect a terminal to the router’s console port.
Checking Conditions Prior to System Startup
Check the following conditions before you start your router:
• The port adapter is securely inserted in its slot.
• All network interface cables are connected.
• A flash disk or flash memory card is installed in the PCMCIA card slot.
• The power cable is connected and secured.
• The console terminal is connected and powered on.