Filter
Top Products
viii
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
OL-5916-01
Preface
Organization
Organization
The major sections of this guide are as follows:
Related Documentation
Your Cisco uBR7100 series router and the Cisco IOS software running on it contain extensive features
and functionality, which are documented in the following resources:
• For international agency compliance, safety, and statutory information for WAN interfaces for
Cisco uBR7100 series routers, refer to the regulatory compliance and safety information document
that shipped with your router.
• For information on installing and replacing field-replaceable units (FRUs), refer to the individual
document for each FRU.
• For information about replacing SDRAM see Memory Replacement Instructions for the Network
Processing Engine or Network Services Engine and Input/Output Controller at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/core/7206/fru/memory/index.htm
• For information on using the flash disk, see the “Flash Memory Card Usage” section on page 6-5
and the Using the Flash Disk document at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/core/7200vx/72vxfru/5819fdsk.htm
Chapter Description
Chapter 1, “Product Overview” Describes the Cisco uBR7100 series universal broadband
router and its major features and interfaces.
Chapter 2, “Preparing for Installation” Describes the steps required to prepare a site before installing
the Cisco uBR7100 series router.
Chapter 3, “Installing Cisco uBR7100
Series Universal Broadband Routers”
Provides instructions to install the Cisco uBR7100 series
router and to connect its network interface cables.
Chapter 4, “System Startup” Describes the procedure for the initial startup of the system.
Chapter 5, “Troubleshooting the
Installation”
Provides basic troubleshooting procedures for the hardware
installation.
Chapter 6, “Maintenance” Describes recommended maintenance procedures.
Appendix A, “System Specifications” Contains the physical specifications and power requirements
of the router.
Appendix B, “Manufacturers for
Headend Provisioning Requirements”
Lists vendors for the auxiliary equipment that is normally
required for a headend installation.
Appendix C, “Cable Specifications” Provides cabling information and pinout information for the
router.
Appendix D, “Frequency Allocation
Tables”
Provides the standard frequency allocation channel plans.
Appendix E, “Site Log” Provides a sample log sheet that can be used to track
maintenance and other changes that are done to the equipment.