Filter
Top Products
Adjustments
CL-S6621 3-56
Key operation on the printer:
(2-2) Adjustment procedures
• DO NOT adjust for other menus not explained here. They are for factory setup
use and changing them will cause the printer to be defective.
• Do not turn OFF the power of the printer until you finish the adjustment.
If it is turned OFF, you need to repeat the adjustment from the beginning.
• The value adjusted here is retained until you change it with the same
procedure. Even if you perform initialization in the “user menu setup
mode”, it is not initialized.
1. Turn on the PC and run the Terminal software.
2. While pressing and holding the [MODE], [FEED] and [STOP] key, turn on the power.
([MODE] + [FEED] + [STOP] + [POWER])
3. The following initial maintenance screen will appear on the PC.
[Transparent sensor sensitivity adjustment, Media: Label paper]
4. Press the [FEED] key to select the transparent sensor menu (“Ini Thru Sensor”).
PAUSE
STOP
FEED
MODE/REPEAT
DOWN
(Previous item / Decrease item)
EXIT
UP
(Next item / Increase item)
SELECT
Caution