Filter
Top Products
Operation Panel
2-47 CL-S6621
(2-2) Hex dump mode
You can print the data in the receive buffer in the hexadecimal form.
For label:
1. While pressing and holding the [STOP] key, turn on the power.
2. When the PRINT LED blinks slowly
(later, it will blink rapidly), release the [STOP] key.
The printer enters hex dump mode and hex dump printing starts.
To exit hex dump mode, turn off the power.
For continuous media:
1. While pressing and holding the [STOP] key, turn on the power.
2. The PRINT LED will blink slowly. When it changes to rapid
blink, release the [STOP]
key.
The printer enters hex dump mode and hex dump printing starts.
To exit hex dump mode, turn off the power.
(3) Factory/Service mode
Operation Description Remarks
All keys + [POWER] Enters factory mode and service mode
(3-1) General
Factory mode and Service mode are available for maintenance.
Factory mode:
You can change the factory-set items such as logical shift of the sensor or head, and
double heat (printing the same dot twice).
In Factory mode, DO NOT change the factory-set values unless you need it,
since there are essential items related to printing accuracy, etc.
Service mode:
You can perform checks such as “head check “and “counter print” to print the total print
length since the printer is firstly used.
DUMP LIST
02 40 30 31 30 30 0D 02 60 30 30 32 30 0D 02 4C .M0100..c0020..L
44 31 31 0D 31 30 30 30 30 30 30 30 30 30 31 30 D11.100000000010
30 30 31 30 31 32 33 34 35 36 37 38 39 3A 3B 3C 0010123456789:;<
[Dump list example]