Filter
Top Products
Maintenance and Service Guide 7-37
Addendum 108431-001 (11-88) to
Manual No. 108033-003
2. Locate and disconnect the signal cable and
the power cable from the back of the mass
storage device in drive position B or C
(Figure 7-40).
3. Remove the retaining screws on the side of
the drive housing assembly.
4. Slide the mass storage device out of the
drive position (Figure 7-41).
Figure 7-40. Disconnecting Cables from Mass Storage
Device B or C.
To replace a half-height storage device in drive
position B or C, reverse steps 1 through 4,
following the power cable connection guidelines
in Table 7-3.
Table 7-3. Power Cable Connections
for Drive Positions B and C
Drive Position System Board Connector
B J111
C J109
Figure 7-41. Removing a Mass Storage Device from
Position B and C.