Filter
Top Products
Maintenance and Service Guide 7-53
Addendum 108431-001 (11-88) to
Manual No. 108033-003
To remove the terminating resistor, complete the
following steps:
1. Locate the terminating resistor on the
fixed disk drive.
NOTE: Terminating resistors are located
in different positions depending on
the manufacturer.
2. Remove the terminating resistor on the
fixed disk drive using needle-nosed pliers
(Figure 7-53).
Figure 7-53. Locating and Removing the
Terminating Resistor.
To install the fixed disk drive in the expansion
unit, reverse steps 1 through 5.