Compaq 386 Personal Computer User Manual


 
7-44 Chapter 7, Removal and Replacement Procedures
Addendum 108431-001 (11-88) to
Manual No. 108033-003
4. Remove the ten mounting screws that
secure the system board to the chassis.
5. Carefully remove the system board from
the chassis (Figure 7-46).
Figure 7-46. Removing the System Board.
To replace the system board, follow these steps:
1. Reverse Steps 1 through 5. Be sure to tight-
en the mounting screws because they
provide proper grounding for the system.
NOTE: When you reconnect the power
cables, refer to the configuration
label on the drive housing assembly
for the location of the connectors.
2. Run the SETUP program.