Filter
Top Products
4-11
Writer: J Abercrombie Project: Chapter 4 Comments: 113733-001
File Name: E-CH04.doc Last Saved On: 5/18/99 2:44 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
❏ In Windows 98 select StartÅSettingsÅControl PanelÅ Power
ManagementÅPower Meter tab.
■ To view the combined percent of total power remaining in all battery
packs in the system, clear the Show the Status of All Batteries check
box.
■ To view the percent of total power remaining in each battery pack in the
system, select the Show the Status of All Batteries check box.
Calibrating a Battery Pack
Calibration increases the accuracy of all battery charge displays.
The calibration utility supports all battery packs that can be used in the
computer.
Use the calibration utility both to check the calibration of a battery pack and to
calibrate or recalibrate a battery pack.
■ A battery pack cannot be calibrated unless the utility reports that it needs
calibration.
❏ A new battery pack can be charged, then used to run the computer
before the battery pack is calibrated. However, the amount of charge
in the new battery pack cannot be reported accurately until the new
battery pack has been calibrated.
❏ Check the calibration of a used battery pack periodically and
whenever battery charge displays seem inaccurate.
■ While a battery pack is being calibrated, it is fully charged, then fully
discharged.
❏ A battery calibration icon in the taskbar displays an Up arrow during
the charge phase and a Down arrow during the discharge phase.
❏ A calibration cannot resume if the calibration is stopped or if the
computer is shut down during a calibration. An interrupted
calibration must be restarted.
❏ After calibration, a battery pack must be charged before it can be
used to run the computer.