Compaq M300 Personal Computer User Manual


 
4-13
Writer: J Abercrombie Project: Chapter 4 Comments: 113733-001
File Name: E-CH04.doc Last Saved On: 5/18/99 2:44 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
3. View the calibration reports in the Status column. The battery numbers
in the Battery column correspond to the following locations:
Battery Number Battery Pack Location
1 Computer battery bay
2 Mobile expansion unit MultiBay
4. Select any location number with “Needs calibration” beside it in the
Status column.
5. Select the Start Calibration button.
Stopping a Calibration
Shut down the computer or select the Stop Calibration button on the Battery
Calibration tab. The Stop Calibration button is visible only during a calibration.
Changing the Primary Battery Pack
The primary battery pack is the battery pack attached to the computer.
NOTE: For information on using a battery pack in the mobile expansion unit
MultiBay, refer to Chapter 6.
CAUTION: If the computer is on, you must initiate Hibernation or
shut down power before removing or installing the battery pack.
Failure to do so will result in loss of information.
WARNING: To reduce the risk of personal injury or damage to
the battery pack, do not crush, puncture, or incinerate the battery
pack or short the metal contacts. Do not attempt to open or
service the battery pack.