Filter
Top Products
44 Setting Up and Using Your Computer
Configuring Your Hard Drives for RAID
Your computer can be configured for RAID, even if you did not select a RAID
configuration when the computer was purchased. For an explanation of RAID
levels and their requirements, see "About RAID Configurations (For
Windows Vista
®
only)" on page 43. For information on how to install a hard
drive, see "Hard Drives" on page 126.
To configure RAID hard drive volumes use the Nvidia MediaShield ROM
utility before you install the operating system onto the hard drive.
Ensure that you set your computer to RAID-enabled mode before you begin.
Setting Your Computer to RAID-Enabled Mode
1
Enter the system setup (see "Entering System Setup" on page 172).
2
Press the left- and right-arrow keys to
Advanced
tab.
3
Press the up- and down-arrow keys to highlight the
Integrated Peripherals
,
then press <Enter>.
4
Press the up- and down-arrow keys to highlight the
Serial-ATA
Configuration
, then press <Enter>.
5
Press the up- and down-arrow keys to highlight
RAID Enabled
, and then
press <Enter>.
6
Press the up- and down-arrow keys to select
Enabled
, and then
press<Enter>.
NOTE: For more information about RAID options, see "System Setup Options"
on page 173.
7
Enable the corresponding “SATA in Primary or second RAID” where your
hard drives are connected
8
Press the up- and down-arrow keys to select
Enabled
, and then press
<Enter>. Press
F10
key and then press <Enter> to exit system setup and
resume the boot process.
book.book Page 44 Wednesday, April 16, 2008 3:33 PM