Filter
Top Products
13. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
14. Press the card retention device back into its original position; push it down until it clicks into place.
15. Ensure that all connectors are properly cabled and firmly seated.
16. Replace the computer cover (see Replacing the Computer Cover), reconnect the computer and devices to electrical outlets, and then turn them on.
17. If you installed a sound card:
a. Enter system setup, select Integrated Audio, and then change the setting to Off.
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the microphone, speaker/headphone,
or line-in connectors on the back panel.
18. If you installed a network adapter card and want to disable the integrated network adapter:
a. Enter system setup, select Integrated NIC, and then change the setting to Off.
b. Connect the network cable to the network adapter cards connectors. Do not connect the network cable to the network connector on the back
panel.
19. Install any drivers required for the card as described in the card documentation.
1
release tab
2
card retainer
1
card retention device
2
tab
NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.