Filter
Top Products
7. Press down the release lever on the side of the drive carrier and pull the Media Card Reader out.
8. If you are not installing another drive in the drive bay:
a. Reinstall the empty drive carrier by sliding it back into the drive bay until it clicks into place.
If you later decide to install another floppy drive or a Media Card Reader in that drive bay, you can slide it into the drive carrier without removing
the carrier from the drive bay.
b. Install a drive panel insert (see Replacing a Drive-Panel Insert).
9. If you are installing another drive in the drive bay, see the appropriate installation instructions.
10. Reinstall the drive panel (see Replacing the Drive Panel).
11. Replace the computer cover (see Replacing the Computer Cover).
12. Connect the computer and devices to electrical outlets, and turn them on.
Installing a Media Card Reader
1. Follow the procedures in Before You Begin.
2. Remove the computer cover (see Removing the Computer Cover).
3. Remove the drive panel (see Removing the Drive Panel).
4. If the 3.5-inch drive-panel insert is installed, remove it (see Removing a Drive-Panel Insert).
Otherwise, ensure that the 3.5-inch drive panel plate is installed.
5. If another device is installed in the drive bay, remove that device (see the appropriate device removal instructions).
6. If no screws are attached to the Media Card Reader, check the inside of the drive panel for shoulder screws. Attach screws to the new card reader.
1
Media Card Reader
2
floppy drive/Media Card Reader carrier
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
CAUTION: Your computer is heavy (it has an approximate minimum weight of 55 lbs) and can be difficult to maneuver. Seek assistance before
attempting to lift, move, or tilt it; this computer requires a two-man lift. Always lift correctly to avoid injury; avoid bending over while lifting. See
your Product Information Guide for other important safety information.
CAUTION: The computer stand should be installed at all times to ensure maximum system stability. Failure to install the stand could result in the
computer tipping over, potentially resulting in bodily injury or damage to the computer.