Filter
Top Products
Expansion Cards 115
5
If necessary, disconnect any cables connected to the card.
6
Grasp the card by its top corners, and ease it out of its connector.
7
If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of
the computer. The brackets keep dust and dirt out of your computer and maintain the airflow that cools your
computer.
8
Lower the card-retention latch and press it into place.
9
Replace the riser-card cage:
a
Align the tabs in the side of the riser-card cage with the slots on the side of the computer, and slide
the riser-card cage down into place.
b
Ensure that the riser cards are fully seated in the connectors on the system board.
10
Replace the computer cover (see "Replacing the Computer Cover" on page 317), reconnect the
computer and devices to electrical outlets, and then turn them on.
11
Uninstall the card’s driver. See the documentation that came with the card for instructions.
1 riser-card cage 3 riser cards (2)
2 slots 4 system board connectors (2)
1
2
4
3