Filter
Top Products
152 IGMP Snooping Commands
www.dell.com | support.dell.com
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the mrouter timeout to 200 seconds.
ip igmp snooping leave-time-out
The
ip igmp snooping leave-time-out
VLAN Interface Configuration mode command configures
the leave-time-out. If an IGMP report for a multicast group is not received within the leave-time-
out period after an IGMP leave was received from a specific port, the current port is deleted from
the member list of that multicast group. To configure the default leave-time-out, use the
no
form
of this command.
Syntax
ip igmp snooping leave-time-out
{
time-out |
immediate-leave
}
no ip igmp snooping leave-time-out
•
time-out
—leave-time-out in seconds. (Range: 0 - 2147483647)
•
immediate-leave
—Specifies that the port should be immediately removed from the
members list after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
• The leave timeout should be set greater than the maximum time that a host is allowed to
respond to an IGMP Query.
•Use
immediate leave
only where there is only one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping mrouter-time-out 200
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping leave-time-out 60