Filter
Top Products
344 VLAN Commands
www.dell.com | support.dell.com
Example
The following example shows how to add VLANs 2 and 5 to 8 to the allowed list of g8.
switchport trunk native vlan
The
switchport trunk native vlan
Interface Configuration mode command defines the port as a
member of the specified VLAN, and the VLAN ID as the "port default VLAN ID (PVID)". To
configure the default VLAN ID, use the
no
form of this command.
Syntax
switchport trunk native vlan
vlan-id
no switchport trunk native vlan
•
vlan-id
—Valid
VLAN ID of the native VLAN.
Default Configuration
If default VLAN is enabled, then the VID=1, otherwise VID = 4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• This command has the following consequences: incoming untagged frames are assigned to
this VLAN and outgoing traffic in this VLAN on this port is sent untagged (despite the
normal situation where traffic sent from a trunk-mode port is all tagged).
• The command adds the port as a member in the VLAN. If the port is already a member in the
VLAN (not as a native), it should be first removed from the VLAN.
Example
The following example g8, in trunk mode, is configured to use VLAN number 123 as the "native"
VLAN.
switchport general allowed vlan
The
switchport general allowed vlan
Interface Configuration mode command adds or removes
VLANs from a general port.
Console (config)# interface ethernet g8
Console (config-if)# switchport trunk allowed vlan add 2,5-8
Console (config)# interface ethernet g8
Console (config-if)# switchport trunk native vlan 123