Filter
Top Products
250 SNMP Commands
www.dell.com | support.dell.com
•
groupname
— The name of the group to which the user belongs.(Range: Up to 30
characters)
•
remote
engineid-string
— Specifies the engine ID of remote SNMP entity to which the
user belongs. The engine ID is concatenated hexadecimal string. Each byte in
hexadecimal character strings is two hexadecimal digits. Each byte can be separated by a
period or colon.(Range: 5 - 32 characters)
•
auth-md5
—The HMAC-MD5-96 authentication level. The user should enter password.
•
auth-sha
—The HMAC-SHA-96 authentication level. The user should enter password.
•
password
— A password (not to exceed 32 characters) for authentication and generation
of DES key for privacy.(Range: Up to 30 characters)
•
auth
-
md5-key
— The HMAC-MD5-96 authentication level. The user should enter
authentication and privacy keys.
•
md5-des-keys
— Concatenated hexadecimal string of the MD5 key (MSB) and the privacy
key (LSB). If authentication is only required you should enter 16 bytes, if authentication
and privacy are required you should enter 32 bytes. Each byte in hexadecimal character
strings is two hexadecimal digits. Each byte can be separated by a period or colon.
(Range: 16 - 32 characters)
•
auth
-
sha-key
—The HMAC-SHA-96 authentication level. The user should enter
authentication and privacy keys.
•
sha-des-keys
— Concatenated hexadecimal string of the SHA key (MSB) and the privacy
key (LSB). If authentication is only required you should enter 20 bytes, if authentication
and privacy are required you should enter 36 bytes. Each byte in hexadecimal character
strings is two hexadecimal digits. Each byte can be separated by a period or colon.
(Range: 20 - 36 characters)
Default configuration
No group entry exists.
Command Mode
Global configuration
User Guidelines
• If
auth-md5
or
auth-sha
is specified, both authentication and privacy are enabled for the
user.
When you enter a
show running-config
command, you will not see a line for this user. To
see if this user has been added to the configuration, type the
show snmp user
command.
An SNMP EngineID should be defined in order to add users to the device.
Changing or removing the value of snmpEngineID deletes the SNMPv3 users database.