Filter
Top Products
Installing System Components 121
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2
Remove the system cover (see "Removing the System Cover" on page 66).
3
Open the expansion card cover (see Figure 3-7).
4
Disconnect the chassis intrusion switch cable from the INTRUSION
connector on the system board (see Figure 3-30).
5
Slide the chassis intrusion switch out of the securing bracket notch, then
remove the switch and its attached cable from the system.
Figure 3-30. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1
Align the chassis intrusion switch with the securing bracket notch (see
Figure 3-30).
2
Slide the switch into the securing bracket notch (see Figure 3-30).
1 securing bracket notch 2 chassis intrusion switch
3 INTRUSION connector on system
board
2
1
3