Filter
Top Products
66 Installing System Components
Installing a Front Bezel Insert
NOTE: If you remove a drive from one or more of the front drive bays, replace the
corresponding insert(s) on the front bezel.
1
From the back of the front bezel, align one of the insert tabs with the
corresponding notch on the bezel, then press the insert into the bezel until
the opposite tab snaps into place (see Figure 3-4).
2
Replace the front bezel (see "Installing the Front Bezel" on page 64).
System Cover
Removing the System Cover
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer, and protecting against
electrostatic discharge.
1
Ensure that your work surface is flat and clean to prevent the system cover
from being scratched.
2
Turn off the system and all attached peripherals.
3
Disconnect the system from the electrical outlet, then disconnect all
peripherals from the system.
4
Press the power button to ground the system board.
5
Rotate the system feet inward into the
closed
position (see Figure 3-5).
6
Lay the system on a flat surface with the system cover facing up (see
Figure 3-5).
7
Using a small flat-blade screwdriver, turn the release latch lock on the cover
release latch counterclockwise to the unlocked position (see Figure 3-5).
8
Lift the cover release latch, then rotate the latch towards the back of the
system to release the cover (see Figure 3-5).
9
Grasp the cover on both sides and carefully lift the cover away from the
system.