Filter
Top Products
24-port NWay Ethernet Switch User’s Guide
Unpacking and Setup
11
♦
The power LED indicator will blink while the Switch
loads onboard software and performs a self-test. After
approximately 20 seconds, the LED will light again to
indicate the switch is in a ready state.
♦
The console LED indicator will remain ON if there is
a connection at the RS-232 port, otherwise this LED
indicator is OFF.
♦
The 100M LED indicator may remain ON or OFF
depending on the transmission speed.
Power Failure
As a precaution, in the event of a power failure, unplug the
switch. When power is resumed, plug the switch back in.