Filter
Top Products
24-port NWay Ethernet Switch User’s Guide
Using the Console Interface
73
traffic) to be let through as early as possible, while
being low enough so that broadcast storms are
completely eliminated.
Press CTRL+S to let the changes take effect. If you wish
these changes to be the default for the switch, return to
the main menu and choose Save Changes.
STP Port State (whether the Spanning Tree Protocol is
enabled or disabled on this port) and Status reflect the
current conditions of the port. They are read-only fields
and cannot be changed.
Configure Slot1 Module
This screen allows you to change the port state of the
module in slot 1 in the case when you would like to
partition a port due to excessive collision, or for
observation, device repair, or security reasons. Great
caution, however, must be observed when disabling a port,
since all data passing through the port will be discarded
by the switch.
To change the configuration of the Slot1 module shown
below: