Filter
Top Products
202
FM-3 Programming Module Reference Manual
Now that all of the motion parameters are setup, the jogs and indexes can be initiated through
assignments to hardware inputs that were made on the assignment view.
Step 5: Creating a Program
Now that the drive setup is complete, assignments are made, and motion profiles are defined,
you are ready to create the program. To do this, expand the Program group in the hierarchy
window, and select Program 0. Figure 84 shows the programming window and the available
instructions.
Figure 84: Program View
The window in the middle of the view allows selection from a list of Program Flow and
Motion instructions. To insert an instruction into the programming window, you can use the
“drag-and-drop” method also used in making assignments. Simply position your mouse
pointer over the instruction you wish to use, click the left mouse button and hold it down.
While holding the button down, move your pointer into the programming window, and
release the mouse button.