Filter
Top Products
Printing on Special Media
3-15
8. Now follow the instructions in Chapters 1 or 2 to select the
correct
Paper Source, Paper Size, and other settings in
your printer software. Then send a one-page print job.
◗ If the ink smears on your document, set the thickness
lever to the + position and reprint; see page 3-13.
◗ If your top and bottom margins are not where you like
them, adjust them in your application software.
However, if the problem seems to be with your paper’s
loading position, you can change it using the
Micro
Adjust
buttons; see page 3-20 for instructions.
To print another document in the manual feeder, load the
paper as described above. To switch back to printing from the
paper tray, press the
Pause button to turn off the Pause light.
Then send another print job.
Printing on Continuous Paper
You can load continuous paper in the built-in tractor feeder on
the back of the printer without removing paper from the paper
tray. Load any type of continuous paper that is between
4 inches (102 mm) and 16 inches (406 mm) wide, such as
greenbar computer paper, fanfold banner paper, or continuous
label paper. Always load paper before you send a print job.
1. Turn on the printer.
2. Set up your printer so there’s enough room in the back to
feed the paper and enough room in front for the printed
pages to stack without obstruction. Position the paper
supply within 3 feet (1 meter) of the printer.
Note:
Make sure that paper
isn’t loaded from the
paper tray before sending
a print job for paper in the
manual feeder. If paper is
loaded from the paper
tray, the printer will print
on it instead of the paper
in the manual sheet
feeder.
When you print on
continuous paper, it is a
good idea to turn on auto
tear-off mode so the
printer paper can advance
to the tear-off position
automatically. Follow the
instructions on page B-8.
Note:
The maximum printable
width is 15 inches
(381 mm) on continuous
paper.
Loire-PLUS.BK.book Page 15 Friday, May 2, 2003 2:56 PM