Filter
Top Products
2640A/2645A NetDAQ
Users Manual
J-24
Out of Memory! Close another application and try again!
You have run out of Windows memory.
Close other applications to free Windows memory and continue operations.
PC time earlier than existing Trend Link data! Verify PC time, wait [nn]
seconds, or create a new Data Set.
This message indicates that the Trend Link Data Set you are trying to initialize or
log to has a timestamp that is newer than the current PC time.
This message can occur under the following conditions:
• The Instrument clock is slightly faster than the PC clock. If NetDAQ Logger
runs for several days, then when the instrument is stopped, the last recorded
timestamp may be later than the PC time. In this case, wait for the PC time to
“catch up” before trying to initialize the Trend Link data file for collecting
additional date. For example, if the PC time is 1 minute behind the instrument
time, wait at least 1 minute before restarting. You can also create a new Trend
Link Data Set.
• The PC clock is losing time. Reset the PC clock to the correct time. If this
problem continues, you may have to replace the battery in your PC that
powers the internal clock.
• The PC clock is set to a new time. You will not be able to log data to an
existing Trend Link file after changing the PC clock to a time earlier than the
timestamps in the Trend Link file. To continue, let the PC time catch up to the
time recorded in the timestamps or create a new Trend Link file.
Performing Rollover.
This is a status message that appears at the end of converting a binary data file to
a Trend Link data file. It indicates that the Trend Link *.now file just created by
the conversion procedure is being rolled over into a *.tlg (history) file.
Plot Maximum must be larger than Plot Minimum!
You tried to configure a Quick Plot where the plot maximum was less than the
plot minimum.
Change your Quick Plot maximum and minimum values such that the maximum
value exceeds the minimum value.