Filter
Top Products
System Features 9
Control panel board
System fault LED glows amber when a hardware or system failure occurs.
Pressing the fault LED reset button turns this LED off, but does not correct
the fault.
Power LED glows green when the server has power and flashes green when
the server is in power saving mode. This LED glows amber when AC power
to the server is on, but the internal (DC) power is off which means there is
power to the server but the server is powered down.
Fault LED reset button resets any of the fault LEDs to its original state. This
button does not correct or clear the fault. If the fault condition persists, the
appropriate LED will turn on again until the fault is corrected.
Power button turns the server on and off.
LAN1 LED blinks green when there is traffic on the LAN1 connector. Glows
amber when the LAN1 connector experiences an interruption in connectivity.
LAN2 LED blinks green when there is traffic on the LAN2 connector. Glows
amber when the LAN2 connector experiences an interruption in connectivity.
Blower fault LED glows amber when one of the blowers has failed or entered
an out-of-tolerance state.
Fan fault LED glows amber when one of the fans has failed or entered an
out-of-tolerance state.
USB port provides front panel access for USB peripherals.
Power LED
Power button
Front panel connector
System fault LED
Fault LED reset button
LAN1 LED LAN2 LED
Blower fault LED
Fan fault LED
USB port
USB connector
8507328.book Page 9 Thursday, February 15, 2001 11:28 AM