Filter
Top Products
12 Gateway 7450R Server System Manual
■ Plug the server into a wall outlet, power strip, or uninterruptible power
supply (UPS).
Starting the server
Before you start the server for the first time, make sure:
■ The power supply is autosensing and it automatically determines the
voltage of the incoming power source.
■ All cables are firmly connected to the proper ports on the back panel of
the server.
■ The server and monitor are plugged into an AC outlet, power strip, or
UPS and that the power strip or UPS is turned on.
To start the system:
1 If you have connected the system components to a power strip or UPS,
make sure all the system components are turned off, then turn on the
power strip or UPS.
2 Turn on the monitor.
3 Turn on any other components connected to the server, such as speakers,
a printer, or a scanner.
Warning For the power supply of this equipment, an approved
power cord has to be used. For a rated current up to 6 A
and an equipment weight up to 6 kg, a power cord not
lighter than H05VV-F, 3 G, 0.75 mm
2
, has to be used.
Warning Zum Netzanschluß dieses Gerätes ist eine geprüfte
Leitung zu verwenden. Für einen Nennstrom bis 6 A und
einem Gerätewicht größer 6 kg ist eine Leitung nicht
leichter als H05VV-F, 3 G, 0.75 mm
2
einzusetzen.
Caution Electricity can flow from connected peripherals into the
system causing a shock. Make sure the server and
peripherals are turned off and unplugged from the power
outlet when you connect peripherals to the server.
8507328.book Page 12 Thursday, February 15, 2001 11:28 AM