Filter
Top Products
Replacing and Adding Internal Devices 45
9
If the card is full-length, insert the card extension into the card guide.
The card extension in slot 1 fits below the card guide and the card
extension in slot 2 fits into the groove in the card guide.
10 Replace the card holder over the card guide and the end of the expansion
card. See the illustration following Step 6.
11 Replace the screw in the expansion card bracket to secure the card. See
the illustration following Step 5.
12 Connect any cables to the card. See the card documentation for the
proper cable orientation.
13 Close the case. See “Closing the case” on page 20.
14 Reconnect the peripherals and the power cord, then turn on the system.
You may need to reconfigure the server after replacing an expansion card. You
may also need to install upgrade software that came with the card. Check the
card documentation for additional information.
Adding an expansion card
When adding an expansion card, you must install an expansion card in slot 1
before you can install an expansion card in slot 2.
Card guide
Card extensions
8507328.book Page 45 Thursday, February 15, 2001 11:28 AM