Filter
Top Products
74 Gateway 7450R Server System Manual
To install the SNMP agent in Windows NT:
1 Add the IP address or hostname of the server to the SNMP setup. This
SNMP service routes SNMP service alerts to ManageX.
2 Install ManageX from the Server Companion CD (SCCD).
3 Run SETUP.EXE from the SCCD. The default directory is \Program
Files\7450R Agent.
4 Restart the server.
5 Setup ManageX. See “Setting up ManageX” on page 75.
Installing the SNMP agent in Windows 2000
The server must be prepared for the server management software.
■ SNMP service must be installed. If not, install SNMP service through
Windows 2000 before you install the SNMP agent.
To install the SNMP agent in Windows 2000:
1 Add the IP address or hostname of the server to the SNMP setup. This
SNMP service routes SNMP service alerts to ManageX.
2 Install ManageX from the Server Companion CD (SCCD).
3 Copy WBEMSNMP.EX_ from the \i386 directory on the SCCD to a local
drive.
4 Open a DOS command prompt window and type expand
D:\WBEMSNMP.EX_ C:\WBEMSNMP.EXE, where D is the drive and
directory where you copied WBEMSNMP.EX_ and C is the drive and
directory where you want to place the expanded file, then presss E
NTER.
5 Type WBEMSNMP at the command prompt, then press ENTER.
The system will display the welcome screen with the title Welcome to the
WMI SNMP Provider Installation Wizard. When the welcome screen is
displayed, continue with the installation.
6 Click Start, then select Settings, then Control Panel.
7 Double-click Add/Remove Hardware.
8 Click Add/Troubleshoot a device, Add a new device, then No, I want to select
the hardware from a list
.
8507328.book Page 74 Thursday, February 15, 2001 11:28 AM