Filter
Top Products
48 Gateway 7450R Server System Manual
8 Replace the card holder over the card guide and the end of the expansion
card.
9 Replace the screw in the expansion card bracket to secure the card.
10 Connect any cables to the card. See the card documentation for the
proper cable orientation.
11 Close the case. See “Closing the case” on page 20.
12 Reconnect the peripherals and the power cord, then turn on the system.
You may need to reconfigure the server after installing some expansion cards.
You may also need to install software that came with the card. Check the card
documentation for additional information.
Replacing the power supply
The 200-W power supply provides all system power.
To replace the power supply:
1 Turn off the system and disconnect the power cord and all peripherals.
2 Open the case. See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.
Expansion cardScrew
E
xpans
i
on car
d
b
rac
k
et
8507328.book Page 48 Thursday, February 15, 2001 11:28 AM