Filter
Top Products
FRU and SDR Load Utility 149
16 bytes. The data on each line are followed by the same data in ASCII
format; nonprintable characters (ch < 32 || ch > 126) are substituted by a
period (.).
Example:
To display the SDR area, type
frusdr -d sdr and press ENTER.
Using a Specified CFG File
The utility can be run with the command line parameter of -cfg
filename.cfg. The filename can be any DOS-accepted, eight-character
filename string. The utility loads the specified CFG file and uses the entries
in that file to probe the hardware and to select the proper SDRs to load into
nonvolatile storage.
Displaying the Utility Title and Version
The utility displays its title:
FRU & SDR Load Utility, Version 2.0, Revision X.XX
where X.XX is the revision number for the utility.
Configuration File
The configuration file is in ASCII text. The utility executes commands
formed by the strings present in the configuration file. These commands
cause the utility to run tasks needed to load the proper SDRs into the
nonvolatile storage of the BMC and possibly generic FRU devices. Some of
the commands may be interactive and require you to make a choice.
Prompting for Product Level FRU Information
Through the use of a configuration file, the utility might prompt you for
FRU information.
3424.boo Page 149 Wednesday, September 2, 1998 9:23 AM