Filter
Top Products
Solving Problems 169
• Certain drivers may require interrupts that are not shared with
other PCI drivers. You can use the SSU to adjust the interrupt
numbers for PCI devices. For certain drivers, it may be necessary
to alter settings so that interrupts are not shared.
• Check PCI interrupt interdependencies among slots and onboard
devices.
Problems with Application Software
If you have problems with application software, do the following:
• Verify that the software is properly configured for the system. See
the software installation and operation documentation for
instructions on setting up and using the software.
• Try a different copy of the software to see if the problem is with the
copy you are using.
• Make sure all cables are installed correctly.
• Verify that the system board jumpers are set correctly. See “Setting
the Jumpers” on page 72.
• If other software runs correctly on the system, contact your vendor
about the failing software.
If the problem persists, contact the software vendor’s customer service
representative for assistance.
Bootable CD-ROM Is Not Detected
Check the following:
• Is the BIOS set to allow the CD-ROM to be the first bootable
device?
3424.boo Page 169 Wednesday, September 2, 1998 9:23 AM