Filter
Top Products
Installing Another Processor 39
Figure 10: Installing a Processor
13. When the cartridge meets resistance, push the two tabs toward each
other (Figure 10) until the processor is fully seated.
14. Reattach the retention module bracket:
a. With the bracket in an open position (perpendicular to the front of
the retention module), slide the open hinge at the left of the bracket
into its receptacle at the left of the retention module.
b. Rotate the bracket to the right until it reaches the retention module.
With your right thumb on the face of the bracket and your right index
finger around the tab at the right of the bracket, slightly pull the tab
outward and to the left to open the latch at the back of the tab.
c. As you open the latch on the back of the tab, slide the right edge of
the bracket onto the retention module and release the tab. If done
correctly, the bracket will latch securely.
15. Reinstall the foam cover.
16. Close the case, as described in “Closing the System” on page 7.
17. Reconnect the power cord and turn on the system.
SEC cartridge
Retention module guide rail
Tab on SEC cartridge
Processor heat sink (must face
away from the system board)
Note:
The foam cover is required
to control airflow past the
processors for proper
cooling. Failure to install the
foam cover could result in
damage to the processors
and other system
components.
3424.boo Page 39 Wednesday, September 2, 1998 9:23 AM